Max RB218 Cordless Rebar Tying Tool

Brand:Max USA Corp
Product Code:RB218
Price: Add to Cart for Price
Qty:     - OR -   Add to Wish List Add to Compare

Max RB218 Cordless Rebar Tying Tool

* REDUCES TYING TIME
About 5 times faster than manual tying. Makes ties in less than 1 sec. per tie with consistent tie strength. High speed tying saves you time and money.

* LI-ION HIGHER CAPACITY BATTERY
Thanks to the Lithium-lon battery technology, the RB218 ties approx. 3,000 ties per charge (Old model RB217 : 2,000 ties per charge), which is 5 times more than Ni-Cd model. Less charging time means more productive work on the jobsites. Also, Lithium-Ion battery has no Memory Effect so you can charge the battery whenever convenient.

* BRUSHLESS TWISTING MOTOR
The brushless electric motor offers higher efficiency and longer lifetime. It increases ties per charge by 35% comparing with older model motor and does not require service caused by brush erosion or dirt on commutator.

* REDUCES RISK OF HEALTH PROBLEMS
Just pull the trigger, this simple operation reduces potential wrist damage such as carpal tunnel injuries. Using the optional extension bar reduces the risk of back injuries.

* NEW ENCLOSED DESIGN
Tool is better sealed to keep dirt and debris out of tool to extend tool life.

* NEW BLOW OUT CHANNELS
MAX recommends daily blow out of tool with compressed air and has added blow out channels to ease cleaning.
 

MODEL
RB218
WEIGHT
5.3 lbs
DIMENSIONS

12"(H) x 4-1/8"(W) x 10-5/8"(L)

TYING SPEED
Less than one second

TIES PER COIL

Approx. 170 to 210 ties

TIES PER CHARGE
Approx. 3,000 ties
RE-BAR SIZE
Mesh x Mesh to #3 x #3
TIE WIRE
TW898(Regular Steel wire),
TW898-EG(Electro Galvanized wire),
TW898-PC(Polyester-Coated wire)
ACCESSORIES
Battery pack JPL91440A (1pc.)
AC Battery charger JC914
Carrying case / Belt hook

Write a review



Note: HTML is not translated!

Bad           Good



Inquiry about the product Max RB218 Cordless Rebar Tying Tool

Your Name:


Your Email:


Message: Note: HTML is not translated!

Enter the code in the box below: